30-Minute Steak Stir Fry Recipe (2024)

FAQs

What are the 3 rules of stir frying? ›

Food & Dining

The first is to cook your protein and your vegetable separately, and combine them only after both are fully cooked. A second rule of thumb for stir-frying: Choose one vegetable per stir-fry. Finally, always remember to add liquid only after everything is more or less finished cooking.

According to Food & Wine, ketchup is the ultimate way to take the flavor of homemade stir fry up a level, thanks to its sweet and sour flavor profile. It just might be the easiest cooking hack to elevate your home cooking to that of your favorite take-out.

For tender beef stir fry, choose a lean cut like skirt steak or flank steak and slice it thinly against the grain. Velvet the beef by marinating it in a mixture of oil, starch, baking soda, and soy sauce for 15 minutes, then quickly pan sear it in a hot pan with oil.

Heat the oil in a large frying pan or wok, then fry the chilli and garlic for 1 min. Add the veg and toss to coat in the oil. Fry for 2-3 mins, then add the soy and chilli sauce, mixing well. Cook for 2-3 mins more until the veg are tender.

Soy sauce, sesame oil, a bit of vinegar, or store-bought stir-fry sauces are easy to add to the dish and most stir-fry recipes will include a suggested mixture of liquid. If you don't really have a sauce planned, a bit of bottled soy sauce and some diced garlic or ginger will make a nice basic stir-fry sauce.

Cornstarch! In his book How to Cook Everything Vegetarian, Mark Bittman recommends mixing 1-2 tablespoons of cornstarch with the same amount of water, and tossing this into the stir fry just when it's almost done. It thickens in seconds, picking up the flavors of everything already in the dish and coating evenly.

Salting. Most cuts of steak benefit from being salted up to an hour in advance of cooking, but especially tougher cuts. In addition to seasoning the steaks, salt helps break down proteins and make the meat more tender. Liberally salt the steaks up to an hour before cooking, then proceed according to your recipe.

While there are several ways to velvet, a pound of meat needs about two teaspoons of cornstarch and two teaspoons of oil, says Leung. You may also include two to three tablespoons of water. For beef, add a 1/4-teaspoon of baking soda for tenderizing. Additional seasonings are optional and vary from recipe to recipe.

How do you make steak more tender and flavorful? ›

On either a cutting board or some other cleanable surface, lay down a bed of salt the size of your steak. Place the steak on top, and completely cover it with salt. Let the salt work on the meat for 15 minutes ( NEVER go longer than 20 minutes). Rinse the salt off the steak thoroughly and pat it dry with a paper towel.

Packages of pre-cut beef strips, beef for stir-fry, are often available in the meat case. Most tender beef cuts, such as sirloin, tri-tip, ribeye, top loin (strip), tenderloin, shoulder center (Ranch Steak), shoulder top blade (Flat Iron) and shoulder petite tender, can be cut into strips for use in stir-fry recipes.

Don't Overcook

Thinly sliced beef only needs to be briefly seared on a hot pan before it's browned and cooked through, about a few minutes. Once the beef is browned on all sides, it is done and can be removed from the pan. Don't overcook the beef, or it will become tough.

A great stir-fry typically consists of four important components: protein, vegetables, aromatics, and sauce. Standard stir-fry starts with one pound of protein and two pounds of vegetables, and a basic stir-fry sauce (recipe below). You can add aromatics or herbs to change the flavor profile of your dish.

Stir-fry onions first, then add hard vegetables such as carrot and broccoli. Quick-cooking vegetables, such as snow peas, leafy greens and bean sprouts, should be added towards the end of cooking. If using vegies that have a combination of both textures, such as gai laan, add the stems first and the leaves later.

The principle behind making a stir fry is to cook your ingredients quickly in a small amount of very hot oil. To keep frying it as fast as possible, it's important to properly prepare all your ingredients. So before you turn up the heat, we recommend you: Marinade any meat, fish or tofu in your choice of sauce.